Wāvtech linkQ 2-channel bass EQ processor and line driver/output converter/IN STOCK TODAY/CLEARANCE

If you're upgrading your audio system and want to make sure there'll be plenty of deep bass in the new system, Wāvtech's linkQ just might be the right tool for the job. This variable bass EQ can provide 0-12 dB of boost anywhere between 30 and 80 Hz. The included wired remote allows you to control the bass level from the driver's seat.Provides a strong clean signal Your aftermarket amplifier needs strong and clean input signals, whether getting them from a receiver's RCA outputs or a factory amp's speaker outputs. The linkQ can produce up to 10 volts of output in either scenario, acting as a line driver using its RCA inputs or as a line output converter using the speaker-level inputs.READ LESSProduct highlights:     2-channel Bass EQ processor        paragraphic bass EQ: 0-12 dB at 30-80 Hz    active 2-channel line driver/output converter    wired remote level control included    designed to work with aftermarket and factory systems    provides up to 10Vrms output    preamp and speaker-level inputs        selectable speaker-level input sensitivity (20V or 40V) via internal jumper    auto turn-on via DC offset or audio detect    gain control and clip light More Info:     12-volt turn-on lead output    speaker-level inputs feature load resistance to prevent factory stereo shut-down    optional plug-in load resistors available for vehicles like some newer Chrysler vehicles that need less resistance for the factory stereo's load-sensing to work    wiring, fuse, and hardware not included with device        18-gauge power and ground leads and a 1-amp fuse recommended    processor: 3-1/8"W x 1-1/8"H x 3-1/2"D (not including terminals and jacks)    wired remote: 1-1/8"W x 1-1/2"H x 1-13/16"D    warranty: 1 year     MFR # LINKQ    Item # 241LINKQ What's in the box: Wāvtech linkQ owner's manualIf you need assistance accessing this owner's manual, please give us a call.     2-Channel line output converter/line driver    2 Phoenix terminals (installed)    Wired remote    5 meter RJ-45 remote cable    2 Mounting tabs (installed)    Two ½" Screws    Ground ring terminal    Owner's manual