DC Audio 10.0K 10000 Watt Mono Block Car Audio Class D Amplifier/Amp+Bass Knob

The 10.0kw competition series amplifier is a 10,000 watt mono block. It is built for 12 volt audio systems. It will not operate on 16 or 18 volt systems. It is a linkable amp and designed to run at 1 ohm per amp or 2 ohms when strapped for 20,000 watts of power. It comes with a bass knob and a clipping indicator. For power inputs it will accept triple 0 awg for power and triple 0 awg for ground. Key Features • 1 ohm stable • Variable low pass filter • Variable subsonic filter • Variable bass boost • Wired remote control • Triple 0 awg power and ground inputs We recommend for installation • 1 upgraded battery under the hood • 3 extra 800ci battery in the rear • Minimum of two 0 awg ran from the front battery to the rear batterys • All 0 awg power and ground inputs on amp must have 0 awg ran to them for a total of 6 runs into the amp • 2 upgraded aftermarket alternators • Dash mounted voltage meter Specifications   Features Voltage 10.0kw Output Power (RMS) 4 ohm 14.4V 3,000W x 1   2 ohm   5,500W x 1   1 ohm   10,000W x 1   1 ohm 16V N/A   1 ohm 18V N/A Input Sensitivity     6V~0.2V Low Pass Filter Switchable     ( @ 24 dB Slope) Variable Hz 35~250 Subsonic Filter Switchable     ( @ 24dB slope ) Variable Hz 10~50 Bass Boost Variable dB 0-9dB Frequency Response   Hz 15-270 Signal to Noise Ratio   dB 100 Damping factor     150< Efficiency @ 4ohm   % Over 90% THD @ 4ohms     Less than 0.1% Fuse Rating     1,000 Amps Linked Fuse Rating     2,000 Amps Indicator Power   Yes   Protection   Yes   Clip   Yes Speaker & Power terminal Mold Type   Yes   Power Gauge 0Ga x 3 Heatsink Length     37 Heatsink Width inch/mm   11.5 Heatsink Height     2.6 Key Features • 1 ohm stable • Variable low pass filter • Variable subsonic filter • Variable bass boost • Wired remote control • Triple 0 awg power and ground inputs