DC Audio A3 7.5K 7500 Watt Mono Block Car Audio Class D Amplifier/Amp+Bass Knob

The 7.5kw competition series amplifier is a 7,500 watt mono block. It is capable of running up to 18 volts for up to 9,200 watts. It is a linkable amp and designed to run at 1 ohm per amp or 2 ohms when strapped. It comes with a bass knob and a clipping indicator. For power inputs it will accept dual 0 awg for power and dual 0 awg for ground. Key Features • 1 ohm stable • Variable low pass filter • Variable subsonic filter • Variable bass boost • Wired remote control • Dual 0 awg power and ground inputs (both must be used) We recommend for installation • 1 upgraded battery under the hood • 3 extra 800ci battery in the rear • Minimum of two 0 awg ran from the front battery to the rear batterys • Both 0 awg power and ground inputs on amp must have 0 awg ran to them for a total of 4 runs into the amp • 2 upgraded aftermarket alternators • Dash mounted voltage meter Specifications   Features Voltage 7.5kw Output Power (RMS) 4 ohm 14.4V 2,000W x 1   2 ohm   4,400W x 1   1 ohm   7,500W x 1   1 ohm 16V 8,600W x 1   1 ohm 18V 9,200W x 1 Input Sensitivity     6V~0.2V Low Pass Filter Switchable     ( @ 24 dB Slope) Variable Hz 35~250 Subsonic Filter Switchable     ( @ 24dB slope ) Variable Hz 10~50 Bass Boost Variable dB 0-9dB Frequency Response   Hz 15-270 Signal to Noise Ratio   dB 100 Damping factor     150< Efficiency @ 4ohm   % Over 90% THD @ 4ohms     Less than 0.1% Fuse Rating     750 Amps Linked Fuse Rating     1500 Amps Indicator Power   Yes   Protection   Yes   Clip   No Speaker & Power terminal Mold Type   Yes   Power Gauge 0Ga x 2 Heatsink Length inch/mm   32.28"/820mm Heatsink Width inch/mm   9.38"/66mm Heatsink Height inch/mm   2.35"/59.6mm Key Features • 1 ohm stable • Variable low pass filter • Variable subsonic filter • Variable bass boost • Wired remote control • Dual 0 awg power and ground inputs (both must be used)