SolarEpic 60A MPPT Solar Charge Controller 150V PV Input 12V/24V Battery System 840W/1680W Solar Panel Controller W/ MH-M80 Meter + Temperature Sensor Works with Lead-Acid & Lithium Batteries

【High PV Input Power】This 60 amp MPPT Solar Panel Charger works with 840W Solar Panel on 12V Battery System and 1680W on 24V Battery. 【Compatible with a variety of batteries】Negative grounding design, four load control modes, supports lead-acid and lithium batteries. 【Powerful electronic protections】Eight electronic protections, including reverse polarity protection(for battery and array), solar short circuit protection, over-temperature protection, load short circuit protection, load over-current protection, heat sink temperature limit protection, over-volt / low-volt protection and battery shedding protection. 【OLED screen and MH-M80 Meter】The controller has a 1.3 inches OLED screen and a function button. MH-M80 Meter was attached, which can display system operating information and error indications. In addition to that, 3 status LEDs provide system status at a glance. The meter can easily set the parameters of the controller. 【4-stage battery charging】4-stage battery charging algorithm for rapid, efficient, and safe battery charging. The maximal wire size of the controller is 3AWG(25mm2).   Product Description Technical Data 60A 150V MPPT Solar Charge Controller Nominal System Voltage: 12V, 24V Rated Charge Current: 60A Rated Load Current: 30A Max. PV Open Circuit Voltage: 150V Max. PV Input Power: 840W (12V battery) / 1680W (24V battery) Max. Wire Size: 25mm2 / 3AWG Data & Communications Communication Port Dual RJ45 Communication Protocols Private protocol and MODBUS PC Software SolarMate Meter MH-M80 / MH-S80 Dry Contact Via RJ45 port   Charging status / Load output status / Error LED Function button Digital OLED display Temperature sensor terminals Dual RJ45 serial communication ports Input and output terminals (PV+/PV-/BAT+/BAT-/LOAD+/LOAD-) Dedicated for grounding wire Reverse fixing hole Mounting holes for positively fixed fittings Terminal cover plate   SolarEpic NS24H60 Solar Charge Controller 60A: Built with advanced power tracking technology to optimize the working of your solar charger system. The controller features a smart tracking algorithm that maximizes the energy from the solar PV module(s) and charges the battery. It supports lead-acid and lithium batteries. MH-M80 Remote Meter: The digital Remote Meter displays system operating information, error indications. Information is displayed on an OLED display. Additionally, 3 status LEDs provide system status at a glance. The Meter can easily set the parameters of the controller. It can be flush mounted in a wall or surface mounted using the mounting frame(included). The MH-M80 is supplied with 3.3 ft (1.0 m) of cable(Can be extended), a mounting frame, and mounting screws. The MH-M80 connects to the RJ-45 port on the MPPT controller. Remote Temperature Sensor: It is used to sense the environment's temperature. If the remote temperature sensor is not connected to the controller, the default setting for battery charging or discharging temperature is 25 °C without temperature compensation. Put this sensor near the battery.