Pascal Marani PDAXPRO3 2.1 Channel Power Amplifier Module AUTHORIZED DEALER!!!

Pascal Marani PDAXPRO3 2.1  Outstanding Performance High power output: 2 x 800W+2000W@ 4Ω                             2 x 1500W @ 8Ω (BTL)Switched-Mode Power Supply with PFC and auto voltage sensingPascal Class D Amp Module - full bandwith PWM modulator with ultra low distortionFull protection circuitry including Over-Current, Over/Under-Voltage, Output DC and Over-TemperatureExcellent sonic performance with 24bit high end converters coupled with 96kHz sample rate Top-grade DSP Engine 10 Bell + 2 Shelving per input channel5 band parametric equalization per output channel, selected as Bell, Low/High Shelving variable QOutput features a precision dynamic range controller composed of a RMS Compressor with selectable ratio and variable knee and Peak LimiterAdjustable Delay time up to 600ms for input channels, and up to 10ms for output channelsInput channel includes a Noise Gate function, RMS Compressor Pink/White noise generator, sophisticated Dynamic Loudness functioncoupled with 96kHz sample rate Direct PC/Network Connection Rs485 connection for system setup, monitoring and control via fully manageable remote PC software Control 4 Preset Selection by using rotary encoder switchSecurity Lockout Power & Amplifier section Number of Channels 2.1 Max Output Power at 4 ohms 2000W+800W+800W, 1500W + 1500W (Bridged) at 4Ω Output Circuitry Class D - full bandwith PWM modulator with ultra low distortion Output Voltage 79 Vp / 158 Vp (unload) / Bridged 154Vp / 308 Vp (unloaded) THD at Rated power 4Ω (1kHz) <0.005% (20 Hz - 20 kHz, 8Ω load, 3dB below rated power) Signal To Noise Ratio >120 dB (A-weighted, 20 Hz - 20 kHz, 8Ω load) Frequency Response 20 Hz - 20 kHz ± 0,15 dB (8Ω load, 1 dB below rated power) Damping Factor >1000 (8Ω load, 1kHz and below) Power Supplies switch mode power supply with PFC (Power Factor Correction) and integral standby converter Operating Range Universal Mains, 85-265V Consumption / Current draw and Thermal dissipation at 230 V 23W / -A / 78.4BTU/h (Idle)39W / -A /--- BTU/h (I/8 max. power at 4Ω) Protections Over-Current, Over/Under Voltage, Output DC and Over-Temperature, Short Circuit Protection Analog Input 2 x XLR electronically balanced, +12dB AD & DA Converters Cs42528 24bit Frequency Response (DSP) 20 Hz - 20 KHz; -0.5dBu at 20 Hz and 20 kHz DSP & Processing DSP Engine MARANI M704 DSP Resolution 24bit (data) x 24 bit (coeff.),54bit accumulation registers,  96 bit precision on intermediate processing data  Parametric Equalization 10 Bell + 2 Shelving per input channel5 band parametric equalization per output channel, selected as Bell, Low/High Shelving variable Q  Filter Type Bell, Low/High Shelving variable Q Filter Gain From -24dBu up to +12dBu by 0.5dBu resolution steps Center Frequency Selectable with a 1/24th of octave resolution step from 20Hz up to 20kHz Bell Filter Q/BW Q from 0.5 up to 10 by 0.1 resolution steps Low/High Shelving Filter Q/BW Q from 0.5 up to 3 by 0.1 resolution steps Crossover Section HPF/LPF Butterworth 6/12/18/24/48dB per octave; Linkwitz-Riley 12/24/36/48dB per octave; Bessel 12/24dB per octave. Filter resolution 1HzSophisticated Dynamic Loudness function Input RMS Compressor Make up from -6dB to +6dB; Threshold from-18dB up to +12dBu; Knee 0~100%; Ratio from 2:1 to 100:1;Attack time from 5ms up to 100ms; Release time from 40ms up to 1000msHold-Time up to 10sec Output RMS Compressor Make up from -6dB to +6dB; Threshold from-18dB up to +12dBu; Knee 0~100%; Ratio from 2:1 to 100:1;Attack time from 5ms up to 500ms; Release time from 40ms up to 1000ms (10ms resolution) DLF Input: On/Off + Amount %Output: On/Off, attenuation from -6dB to 0dB, Q from 0.1 to 10 by 0.1dB resolution steps  Delay 10 ms 10.4us increment/decrement steps per channel General User Preset 4 Front Panel GAIN pot. -∞dBu ~ 0dBuPRESET EQ Rotary encoder switchRed LED (Power); Red LED (Limit); Green LED (Signal presence)2 x XLR female connector (Input)2 x Neutrik® Speakon (Speaker)1 x Locking PowerCON® 20A: AC Link (blue)3 x Line Gain Controller2 x RS485(RJ-45) Connection1 x IEC C13 16A connector; On/Off Power Switch Dimensions 450x95x180mm Weight, Net / Shipping 5Kg / 6Kg Call 801-771-1820 for any questions Or go to Speakers And Amps     CALL 801-771-1820 with any questions!!! We have distributed PRO AUDIO SPEAKERS and Amplifiers for 20 years.  Go to Speakers And Amps to see! We have all the other major PRO Audio Speaker Brands and Models. We have many many more than you see here. We sell to Dealers as well.