Temank PWM MPPT Solar Charge Controller M30 30A AWG7

Brand: Temank Product Model: M30 Charge Model: PWM/MPPT LCD screen display Easy operation interface MPPT+ PWM charging mode Parameter user can reset A key to open and close the load A key to restore the factory settings Battery reverse discharge protection Battery reverse polarity protection Battery under voltage protection Overload, short-circuit protection Automatic temperature compensation function USB 5V charging (for 500mA) for mobile phone Parameter table Parameters / Model MPPT10 MPPT20 MPPT30 MPPT40 Maximum power current 12A 20A 30A 40A Installation  Line（mm2） 4mm2 8mm2 10mm2 12mm2 Installation Line(AWG) 10(AWG) 8(AWG) 7(AWG) 6(AWG) Weight 280g 300g 475g 480 Dimensions 143×89×46（mm） 187*97*61（mm） System load loss ≤13mA Loop Buck ≤100mV   Battery float voltage 13.8V（12V system）/27.6V（24V system） Battery （under voltage) protection 10.6V（12V system）/21.2V（24V system） Battery （under voltage) recovery voltage 12.6V（12V system）/25.2V（24V system） Charge mode MPPT+PWM MODE Operating Temperature -10℃~60℃ Storage Temperature -30℃~70℃ Humidity requirements ≤90％, No condensation Temperature compensation -4mV/Cell/℃ Temperature Probe (built components) NTC 100K  thermistats Maximum open circuit voltage of the solar panel 18V-24V（12V system）36V-48V（24V system） Solar panels maximum open circuit voltage (V) ≤48V   Installation Note: Installing wires, first loosen the screw counterclockwise Ready Qi installation tools and materials, and cable. Please matching suitable cable ensure that the current density <4A/mm2 This will help reduce the line pressure drop. Check the installation site meets the relevant safety requirements, avoid damp, dusty, flammable, explosive and corrosive gases Install the controller fixed to the vertical plane, see Section V mounting aperture and hole spacing. In order to ensure a good controller cooling conditions, the controller on the bottom of each reserved 10cm space As shown on the right wiring sequence: load, battery, solar Battery plate is connected to the controller to be taken to ensure that the load, battery. The polarity of the solar cell panel and controller Before use: external temperature sensor probe into the left of the controller temperature probe interface probe placed in similar battery temperature. (Line extension must be built-in devices of the external temperature probe coextensive Otherwise, the controller will control parameters of the temperature compensation of the error Warning: In order to prevent accidents from occurring, install: non-professionals can not be engaged in loading and unloading operations There is detail information about Temank PWM MPPT Solar Charge Controller M30 30A AWG7 At Factory Price as belew: Temank PWM MPPT Solar Charge Controller M30 30A AWG7 At Factory Price download