Dual 15A Dimmer Module 500µS Advanced Features

The Advanced Features (AF) Dimmer Module is designed for use in Sensor®+ Dimming Series modular rack enclosures. Advanced Features Dimmer Modules enable dimmer-specific feedback of load circuit data while performing digital phase angle dimming in AF-capable Sensor+ dimmer enclosures. The high-density, dimmer modules feature modular installation and removal, fully magnetic circuit breakers and enhanced risetime toroidal filters. APPLICATIONS • Incandescent lighting • Low voltage lighting • Quartz lighting • Neon lighting • Cold Cathode lighting • 2-wire Fluorescent ballast • 4-wire Fluorescent ballast FEATURES • Voltage, current, and temperature sensors in each dimmer • D15AF and D20AF modules are dual density • D50AF modules are single density • D100AF modules are half density • Dual back-to-back SCRs for each circuit • 500μS risetime toroidal filters • High-density modular assembly • Die-cast aluminum chassis • Fully magnetic circuit breakers General • 100,000A Short Circuit Current Rating (SCCR) • UL and cUL LISTED SPECIFICATIONS: GENERAL • UL and cUL Listed for continuous duty at 100% of rated load • D15AF – 1.8kW • D20AF – 2.4kW • D50AF – 6.0kW • D100AF – 12.0kW PHYSICAL • Modular plug-in assemblies • Cast aluminum chassis, finished with textured epoxy paint • Keyed to prevent insertion in inappropriately rated rack positions CIRCUIT BREAKERS • Fully magnetic to eliminate nuisance tripping • 20x inrush current rating • 125%, 10-120 seconds, must-trip rating • Rated for 100% switching duty applications RATINGS • 100,000A Short Circuit Current Rating (SCCR) • Modules withstand hot-patching of cold loads up to full rating Power Device • Sealed, patented assembly • Field replaceable with screwdriver • Two back-to-back SCRs per circuit • One control LED and one output LED per circuit • Integral bonded heatsink • Integral temperature sensor • Built-in voltage and current sensors FILTERING • High quality 500μS risetime* toroidal filters * Risetime measured at full load, at worst case firing angle (90 degrees), from 10-90% of output wave form DIMMER RANGE • Incandescent, low voltage dimming range 100-0% • Dimming range of 2 and 4-wire fluorescent ballast is dependent on lamp ballast combination. Contact ETC for range verification • Sizing of Neon transformer used in dimming applications should be 1.5x greater than size used in non-dimming application Advanced Features** • Advanced Features error messages: - Load dropped below recorded value - Load increased over recorded value - DC on dimmer output - SCR failed on/off - Circuit breaker tripped - Dimmer module removed - Dimmer load absent ** All AF modules support ETC’s Advanced Features (AF) dimmer specific load reporting features when used in AF-equipped racks or packs ORDERING INFORMATION 100-120 Volt Advanced Features Dimmer Modules Model Description D15AF Dual 15A Dimmer Module, 500μS, Advanced Features D20AF Dual 20A Dimmer Module, 500μS, Advanced Features D50AF Single 50A Dimmer Module, 500μS, Advanced Features D100AF* Half 100A Dimmer Module, 500μS, Advanced Features *D100AF is a half-density, double-height module that takes two slots in the dimmer rack Compatible Systems Model Description Installation Racks SR3 Sensor3 Installation racks SR+ Sensor+ Installation racks SR Sensor Installation racks Touring Racks** SP3 Sensor+ 24 module Touring Rack (48-20A dimmers) SP+ Sensor+ 48 module Touring Rack (96-20A dimmers) Portable Packs** SP3 Sensor3 Portable Packs SP+ Sensor+ Portable Packs ** Touring Racks and Portable Packs can be configured with D50AF and D100AF modules. Contact ETC for custom configurations.