Pixracer PRO Autopilot Xracer PX4 Pixhawk Flight Controller M8N GPS Set RC Quadcopter Ardupilot
PIXRACER PRO The Pixracer Pro has been designed primarily for the demanding requirements of small multicopters, but of course can be used on planes and other vehicles which require no more than 8 pwm outputs for controlling escs and motors. Specifications Specifications mRo Pixracer Pro Main Processor 32-bit STM32H743 Cortex M7 RISC core with FPU 460 MHz IO Processor No RAM 1024 KB RAM Flash 2 MB FRAM Crypto / Hash Processor No Accelerometers / Gyros / Mags Accelerometers / Gyros / Mags Sensors – Dampened Bosch BMI085 (6DOF) (internally vibration dampened) Sensors Invensense/TDK ICM-20602 (6DOF)Invensense/TDK ICM-20948 (9DOF) Internal Magnetometer AK09916 inside ICM-20948 Barometer Infineon DPS310 barometer (Very smooth and NO light sensitivity) Interfaces and Protocols 6x UART (serial ports) [2x with HW flow control,1x FRSky Telemetry (D or X types), 2x General Purpose & 1x GPS+I2C]. 1x PPM sum input signal8x PWM outputs (all D-Shot capable)1x RSSI (PWM or voltage) input1x I2C1x SPI2x CAN1x SWD (TC2030 Connector)3x Ultra low-noise LDO voltage regulator Supported RC input protocols:Spektrum DSM / DSM2 / DSM-X® Satellite compatible input and binding.Futaba S.BUS® & S.BUS2® compatible input.FRSky Telemetry port output.Graupner SUMD.Yuneec ST24. Connectors – JST-GH– USB-C Pin Headers Yes – 8 Servo Conformal Coating No Extended Testing and Burn In No Custom Carrier Board Support No LED Yes (RGB) Dimensions Width: 36mm (1.42”)Length: 36mm (1.42”) Weight 9.09g (.31 oz) Mounting Holes 4mm holes at 31.5mm spacing, Silicone grommets for m3 screws Protector Case Optional Typical Platforms -Multirotor-Rover-Fixed-Wing-Boats-Submarines-VTOL-Automatic Tractors-Others Compatibility PX4 >1.13.0, Ardupilot Firmware The mRo Pixracer Pro is compatible with the following firmware: ArduPilot-ArduCopter 4.x-ArduPlane 4.x-ArduRover 4.x PX4 -PX4 greater than v1.13.0 (master or beta only until v1.13.1 release) Normal Usage Guide -> BATT_VOLT_PIN= 14-> BATT_CURR_PIN= 15 All connectors follow the Dronecode connector standard. All connectors are JST-GH.Pixracer Pro do not have a safety switch option, If there’s a need to have one a CAN switch is required. Pinout