TinyShield Proto Board

DESCRIPTION This proto board brings all of the TinyShield signals out to a point that you can solder to. All of the signals are marked and are spaced with 0.1″ spacing (same spacing as on the standard Arduino Uno), so a standard 0.1″ header can be used if desired. This proto board can be ordered with or without a top stackable connector. By default, a top connector is not needed since the standard method is to use this proto board as the top board in a TinyDuino stack for the easiest access to the signals. However, when this board is ordered with the top stackable connector, it can be an inner layer of the TinyDuino stack (which can be useful in some projects). TECH SPECS Pins Supported All Shield signals supported VCC, VBATT,+3V3, +5V, VIN, GND, RSV2, RSV1, RSV0, RESET, 0, 1, 2, 3, 4, 5, 6, 7, 8, 9, 10 - SS, 11 - MOSI, 12 - MISO , 13 - SCK, AR - AREF, A0, A1, A2, A3, A4/SDA, A5/SDL Pins IO0 and IO1: These are also the hardware UART serial receive (RX) and transmit (TX) signals.