Tiny Trainer V2 Ultimate DRL LED Kit

Attention!! This product is going to be small batch made to order. If you place any order it will be built, tested, and shipped. Please allow additional time for order to be built.   This has a built in 2-6s input 3 Amp 5 volt regulator for the LEDs. You still need to power the RX/VTX pads from a separate source.  Picked up a Five33 Tiny Trainer v2 from FlyFive33.com ? If not get one here: https://flyfive33.com/product/tinytrainer-v2-frame-kit/ Then pick up this kit to make it easy to light up like the big quads.   Notes. The LEDs for the arms are a tight fit and are mean to press fit in to the plastic notched area. They will not rest on your motor wires. If they do not fit you may need to shave off the edge of the PCB with a file or razor blade.    New Feature!!: Added easy mounting for TBS Unify Pro32 and standard RX that follows the 2.54mm pitch of the TBS Unify & Tracer RXs. Installation:  Peel off the VHB on top and place in top canopy after mounting RX and VTX.  Contains:  Standard Kit:  1x TTv2 Core LED + mounting Board 4x TTv2 Arm LEDS 4x Short LED wires  Pro Kit:  (add LEDs to bottom of arms.) Standard Kit Plus: 4x TTv2 Under arm LEDs  1x 2' Addressable LED wire kit    Betaflight Setup.  Here is a quick CLI command config for LEDS # featurefeature LED_STRIP# ledled 0 2,3::C:1led 1 3,3::C:1led 2 4,3::C:1led 3 5,3::C:1led 4 6,3::C:1led 5 7,3::C:1led 6 8,3::C:1led 7 7,5::C:10led 8 8,6::C:10led 9 9,7::C:10led 10 10,8::C:10led 11 11,9::C:10led 12 12,10::C:10led 13 13,11::C:10led 14 14,12::C:10 Save