Toyota ifs steering box mount (flat pitman arm)

get that ifs steering box moved ahead and lowered to use a flat pitman arm and add strength to the box comes with 2 plates for both sides of frame expect around a 1 week turnaround time  Installation.  This mount is built to save time and get your steering box ahead to run offset rear springs up front or TG springs. You shouldn’t need to do any core support trimming or if installed properly also you won’t need to extend your steering shaft on most applications. A flat pitman arm is recommended but a drop arm will work too!  1. remove steering box and clean up frame behind box with a grinder preferably also grind the back of the frame flat to get a flat surface for rear plate to mount up.  2. set front frame plate up to frame to mark your holes to be drilled or cut out with torch. The plate should be flat with the bottom of the frame and about 1/4” back from where it hits up front, this will leave you room to get a good weld up there. The holes do not need to be clean the plate will tak