Bulb Seal Gasket - ECamper Rear Section - 42.5"

This is section is to replace just the rear inset gasket on the ECamper, the area above the rear hatch.  It will be pre-cut to 42.5", and you may need to snip off a little fit it perfectly. This seal has an EPDM foam rubber bulb. The bulb is hollow for compressibility and the foam has closed-cell construction, which resists absorption. Specifications: Black Edge Grip Rubber with Bulb, aluminum core Installation These seals push into place to stop wind, dust, and water from entering. The gripping edges have fingers for a strong hold to the top. It is important to clean the fiberglass edge, removing any mildew, mold, dust or grime.  Make sure the area is 100% dry for good friction when installing The core of the gasket is a U shape of aluminum. If the fit is loose, gently squeeze the edges make it grip tighter. There are small vent holes in the bulb, that is normal. When installing, holes should face toward inside of camper. There is no glue or adhesive needed for installation.