iFlight Blitz Whoop F7 AIO [V1.1] 2-6S AIO Toothpick / Whoop Flight Controller (w/ 55A 8Bit 4in1 ESC)

This is our new iFlight BLITZ series AIO FCs for your ultimate build. A future proof all-in-one FC to step up the game and make some more room for future flight firmware development like Betaflight, Emuflight etc. Lightweight, minimum size, minimum work.This could only be achieved by using BGA chipsets instead of ordinary QFP (big size) MCUs and ultra powerful Mosfets for almost any build. Solder your motor wires on and let's go!   Check out our other AIO FCs, as well as the rest of our iFlight selection! Features Separated Flight Control board to minimize electrical gyro noise Pass-through DJI O3 and Caddx Vista/Polar Connector FC PCB can be disassembled from the ESC PCB; Repair allowed! MCU: BGA-STM32F745, 216MHz OSD: AT7456E Blackbox: 16MB Onboard Flash Gyro: BMI270 Specifications FC Specifications MCU: BGA-STM32F745 Gyro: BMI270 Blackbox: 16MB Onboard Flash BEC output: 5V 2.5A  WS2812 LED Strip: Yes Buzzer: Yes Barometer: DPS310 Connector: Micro-USB OSD: IFLIGHT OSD (AT745E） FC Firmware：IFLIGHT_BLITZ_F7_AIO Mounting pattern: 25.5 x 25.5mm φ3mm Dimensions: 35mm x 35mm Weight: 10.5g  BEC: 5V 2A / 3A Input voltage: 2-6S, support LIHV battery Smartaudio / IRC Tramp VTX protocol supported ESC Specifications ESC MCU: BB21 Driver: FD6288 Input voltage: 2-6S Support LIHV battery Output current: 55A, peak value 65A (10 seconds) ESC firmware: Q-H-40 - Bluejay, 0.16, 24kHz Current sensor: ratio 200 (1/10mV/A) BEC: NO ESC Telemetry: NO Bidirectional DShot: Yes(need to use Bluejay firmware) Supports DShot DShot150/300/600/MultiShot/ OneShot etc. Includes iFlight Blitz Whoop F7 AIO V1.1 (w/ 55A 8Bit 4in1 ESC) 2 x Capacitor 470uF/35V 1 x XT30U Male 18AWG cable 70mm 1 x 1.0-7P cable 50mm-28mm 1 x 1.0-7P cable 50mm 4 x M2 silicon grommets 8 x M2x12mm screws 8 x M2 Transparent Nylon Nut 10 x 0.8mm black Heat shrink tube 10mm Wiring Diagram