NewBeeDrone BeeBrain BLV4 AIO Flight Controller/ESC - Choose Receiver
Attention! The BeeBrainBLV4 OSD might not be compatible with third party cameras. If you are planning to use it for a customized build, please be aware it only supports the cameras below: NewBeeDrone BeeEye Camera Runcam Nano4 Specifications BeeBrain BLV4 ELRS: MCU: STM32F411 ESC Firmware: S-H-40 - Bluejay, 0.16, 48kHz. ESC Specifications: 4 channel 12A ESC ESC Connector: JST-1.0 3Pin NBD OSD (Betaflight OSD Compatible) Weight: 6.5 grams (including antennas and battery connector) Size: Outer dimensions 29 x 29 x 7.6 mm Holes: 25.5 x 25.5 mm Battery input: 1S Connector: PH2.0 UART2 TX and RX for onboard EXPRESSLRS receiver (SX1280) UART1 TX and RX free VTX Adjustable power: 5mW-25mW-SmartMAX. SmartMAX will automatically adjust the VTX power according to the board temperature. When the board temperature rises, the VTX power will be automatically reduced. When the temperature is low, the maximum output power can be up to 400mW BeeBrain BLV4 GHOST: MCU: STM32F411 GYRO: BMI270 VTX: Switchable output power from 5mw- 25mw(for Racing) - SmartMAX(SmartMax up to 400mw) with BeeTX 5.8Ghz Antenna ESC: 12A BLHeliS Pre-Flash with Bluejay 0.18 target: S-H-40 48kHz ESC Connector: JST-1.0 3Pin OSD: NBD7456 Graphical OSD compatible with Betaflight OSD Receiver: GHOST 2.4G receiver with GHOST 2.4G qT Antenna Flight Controller Weight: 6.5g(Include antennas and battery connector) Flight Controller Size: Outer dimensions: 29x29x7.6mm Flight Controller Holes: 25.5x25.5mm Battery input: 1S Uart2: Tx for GHOST 2.4G Receiver Uart1: Tx&Rx free Power Connector: NBD-PH2.0 connector Includes BeeBrain BLV4 ELRS 1 x BeeBrain BLV4 Flight Controller w/ ELRS 4 x Grommet 4 x Screw 1 x Receiver T-Antennas 1 x Receiver Antennas 1 x VTX Antenna BeeBrain BLV4 GHOST 1 x BeeBrain BLV4 GHOST Flight Controller w/ GHOST 4 x Grommet 4 x Screw 1 x qT Antenna 1 x VTX Antenna Firmware BeeBrain BLV4 ELRS: BeeBrain blv4 ELRS3.0 receiver firmware BeeBrain blv4 ELRS2.0 receiver firmware BeeBrain blv4 ELRS Betaflight 4.4 firmware BeeBrain BLV4 GHOST: BeeBrain BLV4 GHOST Betaflight 4.4 firmware All firmware can be found on NewBeeDrone Github Page. Note: For the ELRS variant, during the binding process, power up the drone 3 times; on the third time you plug in power, the ELRS Receiver will get into binding mode. We are still trying to work on the ELRS firmware and make it able to just click the boot button to get into bind mode. We will update this in the near future. Check out the video below by CiottiFPV to see how to get into bind mode. Thanks, bro, for showing this. lol