XDB102-4 Diffused Silicon Pressure Sensors (12.6*10mm)

Features CE conformity; Measuring Range: -100kPa…0kPa～20kPa…70MPa; Isolated structure, for a variety of fluid medium pressure measurement; SS 316L; Small Size：φ12.6mm, lower package cost; Provide OEM, flexible customization. Applications Pressure measurement of automobile engine oil; Engineering machinery, water pumps, equipment; Industrial process control; Urban water supply system. Specifications Structure conditionDiaphragm material: SS 316LHousing material: SS 316L Pin wire: Kovar/100mm silicone rubber wire Back pressure: tube SS 316L (gauge and negative pressure only) Seal ring: nitrile rubber Electrical Condition Power supply: ≤2.0 mA DC Impedance input: 2.5kΩ ~ 5 kΩ Impedance output: 2.5kΩ ~ 5 kΩ Response: (10%～90%)：<1msInsulation resistance: 100MΩ,100V DC Over pressure: 2 times FS Environment Condition Media applicability: fluid which has no corrosion on stainless steel and nitrile rubber Shock: No change at 10gRMS，(20～2000)Hz Impact: 100g，11ms Position: Deviate 90° from any direction, zero change≤±0.05%FS Basic Condition Environment temperature:（25±1）℃ Humidity:（50%±10%）RH Atmospheric pressure: (86~106) KPa Power supply:（1.5±0.0015）mA DC   Parameters（@1.5 mA DC）  Item Min. Typ. Max. Units Linearity ±0.2 ±0.25 %FS,BFSL Repeatability ±0.05 ±0.075 %FS Hysteresis ±0.05 ±0.075 %FS Zero output ±2.0 mV DC FS output 45 100 mV DC Compensated temp. range 0～70 ℃ Working temp. range -40～125 ℃ Storage temp. range -55～150 ℃ (no Sealing ring) Zero temp. error ±0.75 ±1.0 %FS @ 25℃ Full temp. error ±0.75 ±1.0 %FS @ 25℃ Long term stability error ±0.2 %FS/year  Note： 1. The above performance indicators are tested under the benchmark conditions. 2. The temperature range for temperature drift test is the compensation temperature range. Product Dimensions Wiring Guidance   Pin Electrical connection Wire color 4 +OUT Red 10 －OUT Blue 11 －IN Yellow 12 +IN Black   Installation & Tips   Description:1. When installing O-ring or PTFE ring, keep PTFE ring installed in the side without   pressure;2. Screw cannot be lifted to the sensor housing;3. The figure shows the installation of elastic ring with holes；4. The picture shows the pressure transmitter suspension installation, and make sure there is a gap between the radial and axial of the sensor ring and the base to avoid pressure is transmitted to the sensor diaphragm.