X12 AIO 5-IN-1 Flight controller built-in 12A ESC and OPENVTX Support 1-2S
The world first 5-IN-1 AIO flight controller, OPENVTX(up to 400mw), 12A Brushless Blheli_S ESC and Betaflight OSD coming out recently.It comes with onboard SPI ELRS receiver which support ELRS TX module 2.x firmware, and also provide other receiver option like SPI Frsky receiver which support Frsky D8/D16 , REDPINE and SFHSS.This is an amazing flight controller for Brushless whoop. You could get unbelievable RX and VTX range by using this flight controller. Specifications:Brand Name: HappymodelItem Name: X12 AIO 5-IN-1 Flight controller built-in 12A ESC and OPENVTXBetaflight firmware target:ELRS Version: CRAZYBEEF4SX1280FRSKY Version:CRAZYBEEF4FRFLYSKY Version:CRAZYBEEF4FSPNP Version:CRAZYBEEF4DXLITE Version:CRAZYBEEF4SX1280VTX antenna: U.FLWeight: 5.1gSupport 1-2S Lipo/LIHV batterySize: 30mm*30mm*8mm Flight controller X12 ELRS V2.1 flight controller built-in ELRS 2.4G receiver Target: CRAZYBEEF4SX1280X12 Frsky V2.1 flight controller built-in FRSKY 2.4G receiver Target: CRAZYBEEF4FRX12 Flysky V1.0 flight controller built-in Flysky AFHDS-2A 2.4G receiver Target:CRAZYBEEF4FSX12 PNP V1.0 flight controller without onboard receiver Target CRAZYBEEF4DXX12 LITE V1.0 flight controller built-in ELRS 2.4G receiver Target:CRAZYBEEF4SX1280MCU:STM32F411CEU6 (100MHZ, 512K FLASH)Sensor: ICM20689 or BMI270 or ICM42688P(SPI connection)Mount hole size: 25.5mm*25.5mmPower supply: 1-2S battery input (DC 2.9V-8.7V)Built-in 12A(each) Blheli_S 4in1 ESCBuilt-in Betaflight OSD(SPI Control)Built-in 5.8G OpenVTX 0mw~400mwBuilt-in ExpressLRS 2.4G,Frsky D8/D16, Flysky AFHDS-2ABuilt-in voltage meter sensor , voltage meter scale 110Built-in current meter sensor , current meter scale 470 Onboard 4in1 ESC Power supply: 1-2S LiPo/LiPo HVCurrent: 12A continuous peak 15A (3 seconds)Support BLHeliSuite programmableFactory firmware: Z_H_30_REV16_7.HEXDefault protocol: DSHOT300Support Bluejay firmwareWhen use Blujay firmware with 48khz, should set startup power to 1100/1200 Onboard SPI ExpressLRS 2.4GHz Receiver Packet Rate option: 50Hz/150Hz/250Hz/500HzExpressLRS Firmware version: V2.0RF Frequency: 2.4GHzAntenna : SMD antennaTelemetry output Power: <12dBmReceiver protocol: SPI ExpressLRSCompatible with ExpressLRS V2.0 TX ModuleCouldn’t flash separately ExpressLRS firmware Onboard 5.8g OPENVTX Firmware version: OPENVTXSmartaudio v2.1PIT Mode supportRCE Mode supportChannels:48chTransmitting Power: 0/RCE/25mw/100mw/400mwPower supply: DC 5VCurrent (5v): <650ma (400mw)Antenna connector: U.FL