2006-2012 Ford Lincoln Mercury / 4-Button Remote Head Key 164-R7040 / FCC: OUC6000022

FORD 4 BUTTON REMOTE HEAD KEY WITH STANDARD BLADE FCC ID: OUCD6000022 IC: 850K-D6000022 Chip :Ford 4D-63 80-bit Keyway: Standard TR47 Frequency: 315 MHz Battery: CR2032 Buttons: Lock, Unlock, Panic, Trunk Replacement for PN: 164-R7040 5914457 6E5T-15K601-AD   KEYS ARE UNCUT. CONTACT ZIPPYLOCKS@GMAIL.COM TO DISCUSS CUTTING SERVICES PRIOR TO PURCHASEFits: 2007 – 2012 Ford Edge 2007 – 2012 Ford Escape 2009 – 2012 Ford Expedition 2007 – 2012 Ford Explorer 2007 – 2009 Ford Five Hundred 2009 – 2012 Ford Flex 2010 – 2010 Ford Focus 2007 – 2009 Ford Freestyle 2007 – 2012 Ford Fusion 2010 – 2012 Ford Mustang 2008 – 2012 Ford Taurus 2008 – 2009 Ford Taurus X 2006 – 2012 Lincoln MKS 2007 – 2009 Lincoln MKX 2006 – 2012 Lincoln MKZ 2007 – 2009 Lincoln Navigator 2006 – 2009 Lincoln Zephyr 2007 – 2011 Mazda Tribute 2005 – 2011 Mercury Mariner 2006 – 2011 Mercury Milan 2007 – 2007 Mercury Montego 2008 – 2010 Mercury Sable Self-program: Yes, If You Currently Have Two Factory Keys That Start And Run Your Ford In Your Possession. Programming Instructions: You Must have Two Master Working Keys (keys that came with the vehicle from factory.) to perform this procedure. If you only have one working key or none at all it must be programmed by a dealer or locksmith! If you do have two working key and one of the keys are copies or clone key. The procedure below won’t work. Your New third (unprogrammed) key must also be cut prior to performing this procedure. 1. Insert an existing (working) key into the ignition cylinder. 2. Turn the ignition cylinder ON (Position 3) and back to OFF (Position 1). Ignition should stay in ON position for at least three seconds but no more than ten seconds. 3. Remove the existing key and WITHIN TEN SECONDS, insert a second working key and turn to ON and then back to OFF. Ignition should stay in ON position for at least three seconds but no more than ten seconds. 4. Remove the second key, insert the New (unprogrammed) key before twenty seconds have elapsed and turn to ON. Leave it in the ON position for at least six seconds and turn back to OFF. 5. If the new key has been successfully programmed it will start the vehicle and operate the remote keyless entry system. The theft indicator light will light up for three seconds to indicate the key was successfully programmed. If the new key was not successfully programmed, repeat steps 1-4. If the remote portion of the remote did not program but the key will start the vehicle, then please perform the procedure below to program the remote portion of your remote head key.