2023+ Toyota Corolla GR and Hatchback Fog Light Tint Pre-Cut Overlay

Transform the appearance and functionality of your 2023+ Toyota Corolla GR and Hatchback fog lights with this high-quality vinyl overlay set. Choose from four distinct options - smoke, light smoke, blue smoke or JDM yellow - for enhanced style and visibility. Preserve your fog lights from weather damage while elevating the look of your vehicle and setting yourself apart from the pack. Fitment: For 2023+ Corolla GR and Hatchback XSE FrontBumper Fog Light High-Quality Material: Can withstand all kinds of weather (5 - 7 Year Durability) Air Release, Scratch Resistance, Protective Liner Smoked or JDM Yellow Tint Vinyl Sticker, Changes Front of Vehicle to Look More Aggressive  Easy Application Comes in Pair (left and Right SMOKE OUT, LIGHT SMOKE, BLUE SMOKE, or JDM YELLOW) ** NOTE ** Not Actual Fog Light Replacement, This product is an overlay that covers the existing fog light How to Install For Best Results Tools: Heat Gun or Blow Dyer / Padded Glove or Felt Tip Squeegee Rinse / Soap your reflector to get rid of debris prior to application Peel off the Fog Light Overlay Align the Fog Light overlay to the edge that is nearest to the middle of the front bumper Soft glove / microfiber towel to put on your fingers to begin applying the overlay on the light. If not, your fingers will work If using your fingers, lay it on the middle of the fog light and at the sametime apply a small amount of heat with a heat gun or blowdryer, continously, throughout the laying process. You can heat it up till it feels warm to the touch, once it is more malleable, start moving your finger in a circular motion from the middle of the foglight and keep laying / moving toward the outer portion of the foglight in a circular motion. If you have a blow dryer or heat gun, use it to get rid of any tiny bubbles and improve adhesion Since it is a circle and the bulb is rounded it may be a tad harder to apply. REMEMBER** to lay in a circular motion (from middle toward outer of fog)  Stretch as much as possible and use a heat gun to shrink after you have met the desired placement, this will get most if not all the wrinkles out of your overlay. BUT MAKE SURE to smooth it down as much as you can before heating the overlay. If there are bubbles make sure you press firmly with your finger and swipe it towards the closest edge If you mess up, you can peel it off right away with no hassle, and add some heat to get rid of the wrinkles. For Best application, use water underneath and squeegee out the water once the desired placement is met