2024+ Tesla Cybertruck Side Mirror Pin-stripe Pre-cut Overlay

2024+ Tesla Cybertruck Side Mirror Pin-stripe Pre-cut Overlay Elevate your Tesla Cybertruck with our 2024+ Side Mirror Pin-stripe Pre-cut Overlays. Add a pop of color to your ride and stand out from the rest. With small changes, make a big impact and add personal flair to your already neck-breaking vehicle. Upgrade your Tesla game today. Specifications: Fitment: For 2024+ Tesla Cybertruck High-Quality Material: Can withstand all kinds of weather (5 - 7 Year Durability) Easy Application (Peel and Stick) Comes in (2 PCS) in a Pair (left and Right Side Mirror Pin-stripe) ** NOTE ** Not Actual replacement, this product is an overlay that covers the existing side mirror with color overlay. How to Install For Best ResultsTools: Heat Gun or Blow Dyer / Padded Glove or Felt Tip Squeegee Rinse / Soap your Rear side mirror to get rid of dust and debris before application Peel off the side mirror overlay  Note: if you mess up placement, peel off the overlay with ease. DO NOT heat up the overlay until the desired placement has been met. Start from the outside of the side mirror and align the overlay edge with the side mirror edge. Once aligned guide the overlay over the first curve, do not fully lay the overlay onto the curve until you have the general placement for the front-facing side of the side mirror. Then once the front face is aligned and tacked down, start slowly swiping upward to get the wrinkles out of the first curve. Peel up the tacked-down front-facing side, guide the overlay to your desired placement and lay it onto the side mirror. You will have an extra hang from the overlay to wrap around the inner portion of the side mirror. Pull the extra hang on the last curve and guide to where the overlay is to sit on the side mirror. The curve on this area will be tricky as well, so slowly swipe and adjust till there is no wrinkles. Start laying from the curve and slowly working your way toward the end of the overlay. Depending on how you lay the overlay, the bottom should sit near or flush to the end of the bottom of the side mirror of the overlay. Once laid the rest of the overlay should fall into place, if not, use one of your free hands to guide the overlay till it covers the entire reflector. Lay the overlay and adjust until the desired placement is met, lift if needed to adjust. Once the placement is met, PLEASE FOLLOW BELOW INSTRUCTIONS FOR ADHESION If you have a blow dryer or heat gun, use it to get rid of any tiny bubbles and improve adhesion If there are bubbles make sure you press firmly with your finger and swipe it toward the closest edge If you mess up, you can peel it off right away with no hassle, and add some heat to get rid of the wrinkles. ** REMEMBER TO POST-HEAT** the vinyl after laying, this will activate the glue behind the overlay which will enhance tackiness.