Bevel Jig for Use With Nordic Edge File Guide

Bevel Jig for use with the Nordic Edge File Guides Pro tool for consistent, repeatable results, v2. Bevel jig for experienced makers who already own the Nordic Edge file guides (fits v5-Short, v5 and BigMert) *Because this bevel jig is based on using a file guide, there is no stopper bolt supporting the blade spine. So if using the bevel jig without a file guide, clamp the blade securely to the bevel jig with 2 G-clamps or similar** The Nordic Edge bevel jig is 150 mm wide with two slots for the Carbide Faced File Guide (NOT INCLUDED). The bevel jig is: solid stainless steel construction non-magnetic, steel dust will not stick to it low-friction plastic bottom liner for smooth operation stainless steel blade clamp for holding the tang to the jig Angle is freely adjustable by hand using two thumb nuts Suggested process: Clamp the profiled blade to be ground blade in the File Guide (not included, this assumes you already own one) Insert the file guide in the slot in the bevel jig (tak