Hobbywing XRotor Micro Combo Stack - F7 FC + 60A 4-in-1 BLHeli_32 ESC

The XRotor Micro Combo from Hobbywing continues to impress with its latest iteration. The Micro Combo features a 60A 4-in-1 ESC along with an updated F7 Flight Controller. This new FC is similar to other versions with its OSD, and voltage monitoring, but the F7 now comes with an all-new 5V & 12V dual BEC Circuit and a special interface for the DJI image transmission system. he XRotor Micro Combo from Hobbywing continues to impress with its latest iteration. The Micro Combo features a 60A 4-in-1 ESC along with an updated F7 Flight Controller. This new FC is similar to other versions with its OSD, and voltage monitoring, but the F7 now comes with an all-new 5V & 12V dual BEC Circuit and a special interface for the DJI image transmission system. Make your electronics stack work for you, not the other way around!   VIDEO: Xrotor F7 Convertible Flight Controller Features F7 FC Equipped with STM32F722 MCU which has powerful computing ability and fast running speed, and high sensitivity ICM20602 six-axis motion sensor. Supports BetaFlight, Cleanflight, Butterflight, Inva, and other mainstream FPV firmware. DJI image transmission system port equipped with corresponding flat cable Supports bidirectional DShot digital throttle communication. Unique installation design and shock absorption structure. On-board large capacity Flash memory chip. On-board 5V & 12V dual BEC circuit. On-board Pit Switch module. 60A 4-in-1 BLHeli_32 ESC All codes use damped light mode. Damped light does regenerative braking, causing very fast motor retardation, and inherently also does active freewheeling. The code supports regular 1-2ms pulse width input, as well as Oneshot125 (125-250us), Oneshot42 (41.7-83.3us), and Multishot (5-25us). Dshot signaling is supported at any rate up to at least Dshot1200. The input signal is automatically detected by the ESC upon power-up. High-performance 32-bit microprocessor with a running frequency of up to 48MHz for an excellent performance. Onboard 5V BEC, powering different accessories such as FC, VTX, Camera and LED lights and etc. BLHeli_32 firmware is the third generation BLHeli. Specifications F7 FC Compatible with (Modes): PWM, Oneshot125, Oneshot42, Multishot, Dshot150, Dshot300, Dshot600, DShot1200, Proshot1000 and etc Compatible with (Transmitters): PPM, Spektrum, SBUS, SUMD, SUMH, XBUS, IBUS, JETIEXBUS, CRSF, SRXL Mounting Holes: Convertible 20x20mm / 30.5x30.5mm Programming via: Betaflight/Cleanflight-configurator Firmware: HOBBYWING_XROTORF7CONV Voltage Monitoring: Supported Current Monitoring: Supported  FC Programming: Supported External Buzzer: Supported BEC: 5V@1.5: 10V@1.5A LED Control: Supported USB Port: MicroUSB Size: 32x32mm OSD: Built-in Weight: 3.3g 60A 4-in-1 ESC Connectors: (In/Out) XT60 (w/ Wires Soldered on) /no Input wires: 12AWG-130mm* (Red/Black) Output Wire: No wires but solder tabs Weight / Size: 15.0g / 52x42x6.6mm ESC Programming: BLHeliSuite32 Throttle Calibration: Supported Mounting holes: 30.5x30.5mm LiPo Power input: 3S-6S BEC Output: 5V@ 0.6A Burst Current: 80Ax4 Cont.Current: 60Ax4 Manual Hobbywing XRotor 60A 4-in-1 BLHeli_32 ESC Hobbywing XRotor F7 FC Includes 1x Hobbywing XRotor Micro Combo Stack - F7 FC + 60A 4-in-1 BLHeli_32 ESC 1x Soft Mounting Grommets Set 1x Signal Cable