Happymodel CrazyF4 ELRS AIO 5in1 Flight controller built-in 900MHz(915MHz or 868MHz optional) ELRS Receiver

Happymodel CrazyF4 ELRS AIO 5in1 Flight controller built-in 900MHz(915MHz or 868MHz optional) ELRS Receiver Specifications:Flight controllerMCU: STM32F411CEU6 (100MHZ, 512K FLASH)Sensor: MPU-6000(SPI connection)Original whoop size compatiblePower supply: 1S battery input (DC 2.9V-4.35V)Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 readyBuilt-in Betaflight OSD(SPI Control)Built-in 5.8G VTXBuilt-in Serial-based ExpressLRS 900MHz receiver(915MHz or 868MHz optional)Built-in 5V 1A BECFlight controller firmware target: CRAZYBEEF4DXOnboard 4in1 ESCMCU upgraded to EFM8BB21Power supply: 1S LiPo/LiPo HVCurrent: 5A continuous peak 6A (3 seconds)Support BLHeliSuite programmableFactory firmware: O_H_5_REV16_8.HEXDefault protocol: DSHOT600Onboard Serial-based ELRS ReceiverOperation current: ~100MaRx To FC protocol: CSRFRF Frequency optional: 915mhz or 868mhz(EU)Antenna connector: IPEX4Telemetry output Power: <17dBmFirmware target: Happymodel_RX_ES915RXReceiver protocol: CRSFCould bind with Happymodel ES915TX, Frsky R9M and DIY ELRS TX module(need to flash the same version ELRS firmware)Firmware flash via Betaflight pass-throughOnboard 5.8g VTXOutput power: 25mw~200mw switchableFrequency: 40CHInput voltage: 3.3V 5.5VCurrent consumption: 300mA(type)Frequency: 5.8GHz 5bands 40 channels(include Race band)Smartaudio readyOnboard voltage and Amperage meters settingsVoltage meter scale setting 110Amperage meter scale setting 1175 Bind procedure:1.Supply power to CrazyF4 ELRS flight controller (Plug the USB), wait until the RX LED is off, immediately turn off the power (Unplug the USB), and then repeat the above steps again. When the RX is powered on for the third time, the LED light will start to double-flash, which means that the RX enters into the binding mode2.Insert the ES915TX module or other DIY 2.4G ELRS TX to your OpenTX Radio transmitter, and choose External RF mode to CRSF protocol, then you can find ELRS menu from the Radio system (Need to copy the ELRS.LUA file to the SD-Card tools first), Enter into ELRS and press [Bind], the RX LED on the Flight controller will getting to be solid if bind successfully.3.Receiver LED status meanings:LED solid means bind successful or Connection established; LED double-flash means in bind mode; LED flash slowly means no signal established with the TX moduleNotes: Don’t make the antenna plug get touch with the Motor solder pins, otherwise it would burnt the ESC. Notes: Don’t make the antenna plug get touch with the Motor solder pins, otherwise it would burnt the ESC. Package Included:1*CrazyF4 ELRS Flight Controller