Happymodel ELRS X2 AIO 2-4S Flight Controller Built-in SPI 2.4G ELRS and 12A ESC 25.5mmx25.5mm for Mobula7 HDZERO
shop.makerfire.com
Electronics / Circuit Boards & Components

Happymodel ELRS X2 AIO 2-4S Flight Controller Built-in SPI 2.4G ELRS and 12A ESC 25.5mmx25.5mm for Mobula7 HDZERO

$69.99
{{option.name}}: {{selected_options[option.position]}}
{{value_obj.value}}
Store Logo

Makerfire

View Store

The ELRS X2 flight controller comes with integrated SPI 2.4GHz ExpressLRS receiver and 12A Blheli_S ESC which could support 2-4s. Bigger Mosfet could support high to 12A currents would be better for 2-4S toothpick drone or long range FPV drone. And because the 2.4GHz ExpressLRS receiver is equipped with the SX1280 radio frequency chip with high sensitivity, high packet rate and low latency, this flight controller is the one that all Race/Freestyle pilots needed. Specifications:Flight controllerMCU:STM32F411CEU6 (100MHZ, 512K FLASH)Sensor: MPU-6000(SPI connection)Mount pattern: 25.5×25.5 M2Power supply: 2-4S Lipo batteryBuilt-in 12A Blheli_s ESC eachBuilt-in Betaflight OSD(SPI Control)Built-in SPI ExpressLRS 2.4GHz receiverBuilt-in 5V 1A BECFlight controller firmware target: CRAZYBEEF4SX1280 Onboard 4in1 ESCMCU upgraded to EFM8BB21Power supply: 2-4S LiPo/LiPo HV (7v/17v)Currents: 12A continuous peak 15A (5 seconds)Support BLHeliSuite programmableFactory firmware: F_H_40_REV16_8.HEXDefault protocol: DSHOT150/DSHOT300/DSHOT600 Onboard SPI ExpressLRS 2.4GHz ReceiverPacket Rate option: 25Hz/50Hz/150Hz/250Hz/500HzRF Frequency: 2.4GHzAntenna: On board SMD ceramic antennaTelemetry output Power: <12dBmReceiver protocol:  SPI ExpressLRSCould bind with ELRS 2.4Ghz TX module(Recommend TX module with latest elrs firmware) Onboard voltage and Amperage meters  settingsVoltage meter scale setting 110Amperage meter scale setting 470 Package Included:1*Happymodel ELRS X2 AIO 2-4S Flight controller Bind procedure: Connect ELRS X2 flight controller with computer by Plug USB. Running Betaflight configurator and then move on Receiver tab then hit “Bind Receiver”. The Red LED on the flight controller start blinking fast, it means onboard SPI ELRS receiver is in bind mode. Turn on your radio transmitter and running ELRS.LUA v2 version, scroll down the menu and hit [Bind]. The red LED on the flight controller would get solid first and then start to blinking slowly. It means bind successfully. Re-connect the USB and then you will find link was established.

Show More Show Less