DIY 4-Axis RC Quadrotor PIX PX4 32 Bits Filght control 560mm Foldable Frame 1455 Props 700KV Motor 40A ESC AT9S Radio

4-Axis DIY Drone PIX PX4 Flight Controller 560mm Carbon Fiber Foldable Frame 700KV Brushless Motor 40A ESC 1455 Props AT9S Radio   3 Options , pls check carefully before place the order  .  PNP NO RX  Carbon fiber folding frame kit x1(Unassembled） HYD3508 700kv brushless motor x4(banana plug Soldered ) 1455 carbon fiber propeller x2 Reverse buckle tie x1 Non-folding Landing gear x1 Antenna Holder x1 Servo cable x1 GPS X1 PIX PX4 Flight Controller Set x1       BNF With RX   Carbon fiber folding frame kit x1(Unassembled） HYD3508 700kv brushless motor x4(banana plug Soldered) 1455 carbon fiber propeller x2 Reverse buckle tie x1 Non-folding Landing gear x1 Antenna Holder x1 Servo cable x1 GPS X1 PIX PX4 Flight Controller Set x1 T8FB Transmiter with R8EF Receiver         RTF With Battery   Carbon fiber folding frame kit x1(Unassembled） HYD3508 700kv brushless motor x4(banana plug Soldered ) 1455 carbon fiber propeller x2 Reverse buckle tie x1 Non-folding Landing gear x1 Antenna Holder x1 Servo cable x1 GPS X1 PIX PX4 Flight Controller Set x1 T8FB Transmiter with R8EF Receiver  x1 11.1V 4400MAH 30C 3S1P xt60 x1  Charger x1   More Details:   Frame kit:    Wheelbase: 560mm Fit for Motor:2212-3508(920kv - 700kv) Fit for ESC: 20A-40A Height of the Landing Skid: 190mm Fit for Propeller: 10-12 inch   Propeller:    High quality 100% 3K all carbon fiber board which imported from Japan improve material. Each pair of propellers has perfect dynamic poise and static balancing which balance by manpower. Especially improves the air-powered efficiency and aerofoil stability. High quality ultra-light carbon fiber propellers especially designed for multicopters. Carbon fiber forward propeller*1 Carbon fiber reverse propeller*1 Length:14inch,Pitch 5.5,Main Hole Dia 4mm,Side Holes Dia 3mm,Center distance 12mm Motor: Motor KV: 700KV Shaft: 4.0mm No-load Currency (A): 0.4A Maximum Currency (A): 18.0A Power: 198W Weight: about 90g Input Voltage: 2-4S LOPO Suitable Propeller: 12"-15" Props ESC: Types: long, short Current:  40A Output capacity: continuous current 40A, short-time current 55A (not less than 10 seconds) Power input: 2-4 lithium batteries(Not Included) BEC output: 5V@3A (linear regulator mode - linear mode) Maximum speed: 210,000 rpm for 2-pole motor, 7000 rpm for 6-pole motor, 35,000 rpm for 12-pole motor Size: (Approx) 68x25x8mm   B3 pro Charger : Input Voltage : 100 - 240V AC50 / 60Hz Output Current: 3*800mA Suitable for 2 cell and 3 cell Li-Po Batteries Led Indicator: When power is on : Orange Stand by mode : Green Battery Charging : Red Battery Full : Green   T8FB Technical Parameters 1. Size: T8FB - 173*102*206mm, R8EH - 48.5*21*11mm. 2.Weight: 0.47kg(including R8EH) 3.Frequency: 2.4GHz ISM band(2400MHz~2483.5MHz) 4.Modulation mode: GFSK 5.Channel bandwidth: 400KHz 6.Band width:1200KHz 7.Spread spectrum: FHSS 8.Adjacent channel rejection: >36dBM 9.Transmitter power: <100mW (20dBM) 10.Sensitivity: -104dBM 11.Speed rate:38kbps 12.PWM output: 1.0ms~2.0ms 13.Section precision: 2000, 0.5us per section 14.Cycle:15 ms/per frame 15.Radio T8FB operating voltage: 4.8V~18V 16.Radio T8FB operating current: <110mA 17.Receiver R8EF operating voltage: 4.6~10V 18.Receiver R8EF operating current: <30mA 19.Control distance: more than 1000 meters air, the actual control distance depends on the flying environment.   R8EH Receiver:  Channel: 8CH Operating voltage: max 10V. Operating current: 19-25mA(input voltage 5V) Size: 48.5*21*11mm Weight: 7g Section precision: 4096 Signal output: S-BUS, PPM and PWM PWM signal mode: Green LED, output 8 channel PWM signal. SBUS/PPM signal mode: Both red and green LED on, CH1 output S-BUS signal, CH2 output PPM signal, CH3 to CH8 output PWM signal at the same time.