Skull Rock Band Drummer Figure | 3D Printer Model Files

>>This is a DIGITAL DOWNLOAD | No product will be shipped | After checkout you will be provided the link to download your files. << File Type: STL and 3MF 3D MODEL DESCRIPTION I don’t know about you, but for me, this guy looks a bit drummatic. Assembling Instructions:  Take GEAR_1 and tighten the spring with your fingers as shown in the video, and place it inside BODY, fitting the outer hole of the spring onto the pin inside BODY. Fit GEAR_3 onto GEAR_2 and attach it on top of GEAR_1 so that GEAR_3 is facing downwards. From the outside, thread GEAR_8 so that the pin goes through the holes of the aligned gears on the inside. Attach GEAR_4 onto the pin of BODY. Attach GEAR_5 onto the top of GEAR_3, through the pin of GEAR_8. Place GEAR_6 on top of GEAR_4. Fit CHEST_PLATE on top of everything, aligning the pins with the holes and the slots on the side, as shown in the video. Put GEAR_7 over CHEST_PLATE, fitting it onto the first pin. Attach CHEST_ELIPSE so that the inner diameter touches GEAR_7, as shown in the video. Fit CHEST_ELIPSE_SLIDER below CHEST_ELIPSE, in its designated space. Finish by attaching and gluing the remaining parts   This STL file is recommended for FDM Printers! Approximately Height: 26cm 3D PRINT FILE SETTINGS (FOR 0.4 MM NOZZLE) Line Width/ Nozzle: 0.4 mm Average Speed: 20mm/s (First Layer) / 50mm/s (All the other layers) Recommended Initial Layer Height:  0.12 mm Recommended Layer Height:  0.12 mm Recommended Perimeters/ Walls: 3. Recommended Infill (%): 10% (Gyroid) Needs Support: No. Build Plate Adhesion: None.   The parameters above are recommendations made by our staff; if you prefer, you can adapt them according to your preferences.