Pascal w/ Marani w/FIR PDA515 2-Channel Power Amplifier AUTHORIZED DEALER!!

Pascal w/ Marani w/FIR  PDA515 2-Channel Power Amplifier AUTHORIZED DEALER!! PDA515P is a complete solution dedicated to 1-way or 2-way self-powered loudspeakers. Designed to meet different applications, it provides 2 channels with output power of 500W+150W@4 Ohm . Morever the 2 channels can be bridged into a powerful single channel in order to drive i.e. Subwoofers or Multiple Ways Cabinets with Passive Xovers. In addition it offers a full set of added value features such as on board DSP and RS485 connection for monitoring and control via dedicated PC software. To guarantee maximum reliability, the PDA515P includes a highly efficient universal switch mode power supply with PFC (Power Factor Correction) which provides a total 1kW power to the 2 output channels. The 2 output stages use the Class D moduleThe PDA515P  includes a set of sophisticated processes for loudspeaker, implemented by the powerful MARANI® DSP running 96kHz/24bit [96 bits precision for the internal intermediate processes] and high performance 24bit AD/DA Converters. Processes as Noise Gate, crossover filters, parametric EQs per input and output sections,RMS compressor, alignment delay are available, all in all everything needed to optimize a self-powered loudspeaker. Morever the Clip/Limiter function per channel provides output monitoring to prevent speaker damage with gentle gain reduction at clip threshold, in addition to the efficient heat dissipation system and Over-Heat protection which themselves ensure uncompromised reliability. Furthermore the PDA515P is also equipped with a Dynamic Loudness function and an useful Pink/White noise generator. All setup parameters for input mixing, DSP features and the limiter setting are accessible by using the remote PC software. Outstanding Performance High power output: 500W + 150W @ 4Ω  Switched-Mode Power Supply with PFC and auto voltage sensingClass D Amp Module - full bandwith PWM modulator with ultra low distortionFull protection circuitry including Over-Current, Over/Under-Voltage, Output DC and Over-TemperatureExcellent sonic performance with 24bit high end converters coupled with 96kHz sample rate Top-grade DSP Engine 5 band parametric equalization per input channel7 band parametric equalization per output channels2 filter can be switched to Bell, Low/High Shelving, per channelLow/High Shelving, can be selected as variable Q responseCrossover filters with slopes from 6dB/Octave up to -48dB/Octave including Butterworth, Bessel, Linkwitz-RileyOutput features a precision dynamic range controller composed of a RMS Compressor with selectable ratio and variable kneeInput features a precision dynamic range controller composed of a RMS Compressor with selectable ratio, variable knee and Hold Time.Adjustable Delay time up to 20 ms for input and output channelsInput channel includes a Noise Gate function, Pink/White noise generator, sophisticated Dynamic Loudness function and a High-Pass filter with slopes from 6dB/Octave up to -48dB/Octave including Butterworth, Bessel, Linkwitz-Riley, and FIR Phase correction up to 640 taps Direct PC/Network Connection Rs485 connection for system setup, monitoring and control via fully manageable remote PC software Control Simultaneous control up to 32 units via PC software8 Preset Selection by using rotary encoder switchSecurity Lockout Power & Amplifier section Number of Channels 2 Max Output Power @ 4 ohms 500W  + 150W Output Circuitry Class D - full bandwith PWM modulator with ultra low distortion Output Voltage +/-70 V (SE Mode unloaded) / Bridged +/-140V(BTL Mode unloaded)  THD @ Rated power 4Ω (1kHz) <0.005% (20 Hz - 20 kHz, 8Ω load, 3dB below rated power) Signal To Noise Ratio >120 dB (A-weighted, 20 Hz - 20 kHz, 8Ω load) Frequency Response 20 Hz - 20 kHz ± 0,15 dB (8Ω load, 1 dB below rated power) Damping Factor >1000 (8Ω load, 1kHz and below) Power Supplies Switch mode power supply with PFC (Power Factor Correction) and integral standby converter Operating Range Universal Mains, 85-265V Consumption / Current draw and Thermal dissipation @ 230 V 10.2W / -A / 38.3 BTU/h (Idle)153W / -A / 143.4 BTU/h (I/8 max. power@4Ω) Protections Over-Current, Over/Under Voltage, Output DC and Over-Temperature, Short Circuit Protection Analog Input 1 x XLR electronically balanced, +12dB Analog Output 1 x XLR electronically balanced (Link) AD & DA Converters 24bit Frequency Response (DSP) 20 Hz - 20 KHz; -0.5dBu at 20 Hz and 20 kHz DSP & Processing DSP Engine MARANI® DSP DSP Resolution 24bit (data) x 24 bit (coeff.),54bit accumulation registers,  96 bit precision on intermediate processing data Parametric Equalization 5 filters on input channel 7 filters per output channel  Filter Type Bell, Low/High Shelving Variable Q Filter Gain Input: from -12dBu up to +12dBu by 0.5dBu resolution stepsOutput: from -18dBu up to +18dBu by 0.5dBu resolution steps Center Frequency Selectable with 1Hz resolution step from 20Hz up to 20kHz Bell Filter Q/BW Q from 0.5 up to 10 by 0.1 resolution steps Low/High Shelving Filter Q/BW Q from 0.5 up to 3 by 0.1 resolution steps Crossover Section HPF/LPF Butterworth 6/12/18/24/48dB per octave; Linkwitz-Riley 12/24/36/48dB per octave; Bessel 12/24dB per octave. Filter resolution 1HzSophisticated Dynamic Loudness function and additional High-Pass filter per input section Input RMS Compressor MakeUp from -12 to +12dBu; Threshold from -18dBu up to +12dBu;Knee 0~100%; Ratio from 2:1 to 100:1;Attack time from 5ms up to 500ms; Release time from 40ms up to 1000ms.Input Hold-Time up to 10sec.  Output RMS Compressor Threshold from-18dB up to +12dBu; Attack time from 5ms up to 100msRelease time from 40ms up to 1000ms (10ms resolution) DLF Input: On/Off;Output: On/Off;Attenuation: -6dB ~ 0dB, 0.1 step Internal Noise Generator White/Pink Noise:-40dB~0dB Delay 20 ms, 10.4us increment/decrement steps per channel General User Preset 8 Front Panel GAIN pot. -30dBu ~ 0dBuPRESET EQ 8 positions Rotary encoder switchRed LED (Power); Yellow LED (Link); Green LED (Signal presence)1 x XLR female connector (Input)1 x XLR male connector (Link Output)2 x RJ45 connector (M-LAN Rs485)2 x Locking PowerCON® 20A: AC Mains (blue) - AC Link (white) IEC C13 16A Connector;Power On/Off swithc Dimensions 365x85x110 mm Weight, Net / Shipping 5.84lbs(2.65Kg) / 7.72lbs (3.5Kg) MESSAGE for any questions Or go to SpeakersAndAmps dotcom    MESSAGE with any questions!!! We have distributed PRO AUDIO SPEAKERS and Amplifiers for 20 years.  Go to SpeakersAndAmps  to see! We have all the other major PRO Audio Speaker Brands and Models. We have many many more than you see here.  We sell to Dealers as well.